Cove DW2450 Guide d'installation télécharger pdf (Page 7)

coveappliance.com

INSTALLATION

Installation

PREPARATION

1 Place the unit in front of the opening.

2 Measure the height of the opening, then adjust the

leveling legs until the unit height is slightly less than the

opening height. Refer to the illustration below.

To adjust the front, turn the leveling legs clockwise to

raise and counterclockwise to lower the unit.

To adjust the rear, turn the rear adjustment screw coun-

terclockwise to raise and clockwise to lower the unit.

NOTE: The unit is equipped to prevent the rear leveling

leg from stripping if turned the wrong way. If the rear

leveling leg does not raise or lower, tilt the dishwasher

forward slightly to remove pressure from the leg which

will engage the threads and allow for adjustment.

3 Route the water and drain lines through the access hole

into the adjacent cabinet. If plumbing and electrical

lines are routed through metal, protect the edges of the

access hole to prevent abrasion.

RACK REMOVAL

Remove the racks prior to anchoring the unit.

To remove the upper and middle racks:

1 Pull the rack out to full extension.

2 Pull out on the tab on the side of the rack clips and

remove the clips from the end of each rack glide. Refer

to the illustration below.

3 Pull the rack forward to remove.

To remove the lower rack:

1 Pull the rack out to full extension.

2 Lift up and out.

TA B

Rack removal

REAR

ADJUSTMENT

SCREW

FRONT

LEVELING

LEG

Leveling

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Cove DW2450 Guide d'installation Page 7